IIAR Cling-Tite Ammonia Pipe Marker: (blank)/LIQ/LOW
Label system, physical state, and pressure level with Cling-Tite marker (blank)/LIQ/LOW.
- Meet the International Institute of Ammonia Refrigeration (IIAR) guidelines for proper marking of pipes as specified in Bulletin No. 114, March 2014
- Cling-Tite pipe marker identifies ammonia refrigeration piping and system components: (blank)/LIQ/LOW
- System: (blank); Physical State: Liquid; Pressure Level: Low
- IIAR pipe markers contain the ammonia name and identify the chemical's system, physical state, pressure level, and directional flow
IIAR Self-Stick Ammonia Pipe Marker: HGD/VAP/HIGH
Label system, physical state, and pressure level with Self-Stick marker for HGD/VAP/HIGH.
IIAR Snap Tite™ Ammonia Pipe Marker: HPL/LIQ/HIGH
Label system, physical state, and pressure level with Snap Tite™ marker for HPL/LIQ/HIGH.
Spanish Pipe Marker: Oxígeno
Identify piping system contents and directional flow for pipes containing oxygen.
ASME (ANSI) Pipe Marker: Cold Water Supply
Identify contents and mark the directional flow for pipes used for cold water supply.
OSHA Danger Permit Holder Board: Confined Space - Permit Must Be Completed And Authorized Prior To Entry
Board communicates confined space requirements and holds related permits.
ASME (ANSI) Pipe Marker: Overflow
Identify contents and mark the directional flow for pipes used for overflow.
Cling-Tite – Wraps 360° around, legend repeated upright and up-side-down to be seen from all angles. Legend is sub-printed on the underside of 7-mil polyester, further protected by 2-mil polyester backing. Resists scratches, abrasions, and chemical splashes. Dirt, dust, and liquids wipe off. Ideal for use on higher temperature pipes with range of -40° to 302°F.
Pipe OD 3/4" - 1 1/4" = Marker Size 1" x 11"
Pipe OD 1 1/2" - 2" = Marker Size 1 1/2" x 15 7/8"
Pipe OD 2 1/2" - 6" = Marker Size 2 1/2" x 23 5/8"
Pipe OD 8" - 10" = Marker Size 3 1/2" x 33 1/2"
Identify Ammonia refrigeration piping and system components.